Paradyne 5216 Manuel d'utilisateur

TM 1 Hotwire 5216 Remote Termination Unit (RTU)Customer PremisesInstallation InstructionsDocument Number 5216-A2-GN10-10February 1998Before You Begin

496-1495297-15303cEthernetLinePOWERETHERNETDSLHotwire RTUFerriteChoke 103. Place the large ferrite choke on the Ethernet cable as closely as possiblet

11 6. Close the two halves around the cable and snap the ferrite choke shut. Pressdown on the plastic latch to secure the ferrite choke in place aro

12LED StatusConditionDSL BlinkingONOFFRTU is establishing the DSL link. The LED blinks on andoff about five times per second.The DSL link is now acti

97-153046-PinRJ11 PlugDSL LinePin #1Pin #6 13 LED Symptom ActionDSL and EthernetLEDs are on andthere is no datatransmission.The DSL link and the Ethe

14H The Ethernet interface crossover cable connector uses an 8-pin, non-keyedmodular plug.97-153058-PinPlugEthernet CablePin #1Pin #810BaseT TX D+10B

15 Model 5216 RTU Technical SpecificationsItem Specification*Height x Width x Depth 1.35″ x 6.00″ x 8.75″ (3.43 cm x 15.35 cm x 22.23 cm)Weight 1 lb

16Important Safety Instructions1. Read and follow all warning notices and instructions marked on the product orincluded in the manual.2. Slots and op

17 CE MarkingWhen the product is marked with the CE mark on the equipment label, thisdemonstrates full compliance with the following European Direct

18Declaration of ConformityThis Declaration of Conformity is made by Paradyne Corporation pursuant to Parts 2and 15 of the Federal Communications Com

19 EMI Warnings!WARNING:To Users of Digital Apparatus in Canada:This Class B digital apparatus meets all requirements of the Canadianinterference-ca

2Package ChecklistVerify that your package contains the following:-Model 5216 Remote Termination Unit (RTU)-DSL interface cable with RJ11 modular plu

20Warranty, Sales, and Service InformationContact your local sales representative, service representative, or distributor directly forany help needed

3 When a POTS splitter is used at both ends of the local loop, wiring is connected:H From the demarcation point to the CP POTS splitter, andH From t

4DSL Access without a POTS SplitterWhen the 5216 RTU is installed without a POTS splitter, a second telephone wiring pairis needed for DSL access.97-

5 Installing the DSL Access WiringThe local loop terminates at the punchdown block or NID. Wiring must be connectedfrom the customer premises side o

6Green (T1) and red (R1) are the standard wiring colors used in the next twoillustrations.In the following example, a NID is used without a POTS spli

7 2. Locate the DSL pair of T1/R1 connectors on the customer premises side of theNID or punchdown block. Attach the wiring that will be connected to

8DSL Jack InstallationThe 5216 RTU connects to the local loop via wiring from the demarcation point to anRJ11 wall jack. The DSL twisted-pair wiring

9 Installing the RTUPlace the 5216 RTU on a flat surface with clearance for the rear connectors." Procedure1. Use the RJ11 6-pin cable for the